What problems should be paid attention to in the operation of the switch
Release time：2019-05-22 Clicks： Click
What operation methods should be paid attention to when the switch is operated and what are the specific ones? Let's give you a detailed introduction.
The operation method of the switch affects the performance of the switch. When operating, please pay attention to the following contents. What is the operation method of the switch? Let's learn about it.
Operating method of switching switch
1. Use smoothly shaped switching operators (cams, blocks, etc.). The quick recovery of the driving rod of the switch may lead to the damage of the driving rod and shorten the service life of the driving rod when it is impacted.
2. Do not apply partial load on the driving rod during operation. Otherwise, the local friction may lead to the damage of the driving rod and shorten the service life.
3. Please operate according to the direction of the driving rod. In the needle button type, press the button vertically.
4. Ball pendulum bar and R-shaped pendulum bar should be operated in the direction shown below.
5. For the angle of cam and block of ball pendulum rod, please set it in the range of 30-45 degrees. If the angle is too large, it will cause abnormal transverse stress on the swing bar.
6. Machining the driving rod will exert excessive external force on the internal mechanism of the switch, resulting in the change of its characteristics and the failure of the switch.
7. When using the external swing rod as an operator, in order to determine the additional load according to the operating load of the switch, please confirm the material, plate thickness and so on.
8. Do not use the toggle switch for a long time under the condition of pressing all the time. Otherwise, it will accelerate the deterioration of parts and change their characteristics.