Moisture Treatment of 2*3 Light Touch Switch
Release time：2019-04-25 Clicks： Click
2*3 Touch the switch, if there is humidity, how to deal with it? Specific methods we will give you a detailed introduction below.
What should be done if the 2*3 touch switch is attacked by humidity in the process of using it? I believe that many friends have used such switches, such as those on your mobile phone, and there may be such switches on some computers. Many of these switches are moistureproof handled, but it can not guarantee that all switches have such functions. For example, some switches may not have good moistureproof effect, so In the process of using such switch, if it is affected by humidity, it may affect its normal use effect. At this time, as an ordinary user, it may not know how to solve this problem. So here is a brief introduction for some situations in this regard.
When a customer friend uses a 2*3 light touch switch, if he finds that the switch is damp, don't turn it on or off repeatedly at this time, because it has been damp, the line inside may be affected by dampness and lead to bad contact. If you continue to switch or switch frequently at this time, it will probably lead to short circuit of the line inside, or even short circuit of the line inside. It may cause damage. At this point, we should cut off the power supply, then wait patiently, or test the switch to see if the switch can be used properly. If it can be used properly, then as long as the damp part inside is allowed to dry naturally, it can be used normally.
If 2*3 touch switch is invaded by water when it is used, please pay special attention to find out where the water comes from. For example, in some places, the environment may be very humid, especially in some equipment. If it is found that the environment in which the equipment is placed is very humid, then it is necessary to treat the environment with moisture-proof and moisture-proof treatment to avoid it. Once again, it was affected by humidity. For example, in the southern part of our country, many places may be very wet in different seasons, so some people will have some adverse reactions to the humidity of the switch, so we should try our best to ensure ventilation and ventilation in the room, to avoid the damp once again on the switch. If it is found that the switch is affected by humidity, the correct way is to turn off the power supply. If there is water visible to the naked eye, then clean towels or paper towels can be used to suck up the water visible to the naked eye. Then the switch can be placed in a ventilated place for ventilation. The switch can be dried by natural wind, and then turned on. If the switch is in good condition, it can be installed and used again.
After the 2*3 touch switch is affected by humidity, it may be affected to some extent, and this switch can not be used again. This kind of switch needs to be tested, and can only be used after passing the test. If the test finds that it is not qualified, then the switch affected by moisture may have been damaged, and this part can only be replaced at this time. Please pay attention to the safety of switch operation affected by humidity, especially in the case of high switching-on voltage, it is necessary to pay attention to the safety of operation. I said that the switch is damp, so it may indicate that the surrounding environment is relatively humid, in addition to the switch damp, other parts of the equipment may also be affected by damp, at this time do not rush to switch on the power supply, but should check and analyze the entire equipment circuit.