Can pot pans be used instead of lightly touching switches?
Release time：2019-01-02 Clicks： Click
In connection and use of light touch switch, can we use pot pan instead, and what specific aspects should we start with? Let's give you a detailed introduction.
It is certain that the pot chip can replace the touch switch. If any product can be replaced at any cost, the characteristics of the product itself may be lost. Not to mention, this can be changed through product design, but many functions can not meet the needs of the product. Cause some aspects are not available, serious cause direct unavailability. So under what circumstances should we replace the tap switch with a pot pan?
Touch the switch and the pot piece lightly, all of which play the role of conduction. Secondly, the metal shrapnel inside the light-touch switch is the pot shrapnel. We can understand that the core component of the light-touch switch is the metal shrapnel. Then can we understand that the design of the light-touch switch is to protect the pot shrapnel?
First of all, we should clearly know that the maximum life of light touch switch can only barely reach 100,000 times, and the minimum life of pot pieces is also 100,000 times or more. Secondly, we should know that pot pieces have no fixed ability. It needs to be fixed by sticker or light touch switch or directly welded on PCB board, and the pot pieces belong to metal shrapnel conductive, if so. Surface oxidation, such as dust, may affect electrical conductivity. By understanding these, we should already know what conditions can be used to replace the light switch with a pan piece.
Replacing the touch switch requires better product design sealing, a slot larger than the pot chip itself, or sticking a sticker on it directly, just like the remote control and the button of the mobile phone pot chip. The reason why the touch switch should be replaced is that only one life can not meet the requirements of the product, so it can only be changed from the design to replace it. This is not to say that it is a moulding. The product, which used to touch the switch lightly, now I want to use the pan piece. If that is the case, it will not work.